• Home
• News
• Schedule
• Photos
• About Us
• Rules
  • General Pit Rules
  • Strictly Stock
  • Pure Stock
  • Street Stock
  • Sportsman
  • Open Wheel Modified
  • Spectators
• Our Drivers

RULE BOOK DISCLAIMER

The rules and or regulations set forth herein are designed to provide for the orderly conduct of racing events and to establish minimum acceptable requirements for such events. These rules shall govern the condition of all events, and by participating in these events al participating are deemed to have complied with these rules. NO EXPRESSED OR IMPLIED WARRANTY OF SAFETY SHALL RESULT FROM PUBLICATIONS OF OR COMPLIANCE WITH THESE RULES AND OR REGULATIONS. They are intended as a guide of the sport and are in no way a guarantee against injury or death to a participant, spectator, or official.

The race director shall be empowered to permit reasonable and appropriate deviation from any of the specifications herein or impose any further restrictions that in his/her opinion do not alter the minimum acceptable requirements. NO EXPRESSED OR IMPLIED WARRANTY OF SAFETY SHALL RESULT FROM SUCH ALTERATION OF SPECIFICATIONS. Any interpretation or deviation of these rules is left to the discretion of the officials.

______________________________________________________________________________________________

Bronson Speedway 2013 Safety and General Appearance Rules

SAFETY AND GENERAL APPEARANCE

1. Bronson Speedway officials reserve the right to inspect any car at any time. All cars must have an initial safety inspection prior to competition.

2. All required safety equipment and apparel must be utilized any time the car is on the race track:

A) Racing helmet with minimum of Snell 95 rating.

B) Neck collar or Head and Neck System (Hans device) highly recommended.

C) SFI approved Fire Suit. No holes or torn suits will be permitted.

D) Fire resistant racing gloves only. No mechanics gloves allowed.

E)Fire resistant racing shoes (unless otherwise noted) .

3. Window nets are required on the driver’s side of all cars on all vehicles in all divisions.

Nets must latch at the top and be operational from inside and outside the car.

4. Aluminum racing seat mandatory (unless otherwise noted in Division rules).

5. Drive shaft must be painted white.

Drive shaft loops required on both front and rear of drive shaft. Loops should be made of 1? wide x 1/4? thick steel, and be within 12? of front and rear universal joint. Must be able to catch drive shaft in event of shaft failure. No chains will be permitted as loops.

6. Battery shall be secured to frame of car and must be encased.

7. Lead ballast only. Must be painted white, marked with car #, and secured to frame of vehicle with minimum (2) 1/2? bolts. 50 pound maximum per block.

8. All cars must have front and rear tow hooks. Hooks must be strong enough to support weight of vehicle when towed.

9. All cars must have a radiator overflow container. Water is only acceptable coolant (may not blow out from engine compartment.)